standard pressure
英 [ˈstændəd ˈpreʃə(r)]
美 [ˈstændərd ˈpreʃər]
网络 标准气压; 标准压力; 标准大气压; 標準壓力
英英释义
noun
- a unit of pressure: the pressure that will support a column of mercury 760 mm high at sea level and 0 degrees centigrade
双语例句
- Dependence of flashover voltage on gas pressure has been measured in vacuum and in atmospheric air using 10/ 30-nanosecond pulse power. The scope of gas pressure is between 8 × 10-4 Pa and standard atmospheric pressure.
对纳秒脉冲（10/30ns）下真空绝缘闪络电压随气压的变化趋势进行了实验研究，探讨的气压范围介于8×10-4Pa至标准大气压之间。 - By converting test condition to the standard pressure condition, calculation accuracy of average pressure impulse coefficient method is superior to that of tangent method.
换算到标准压强条件下，平均压强冲量系数法的计算精度优于切线法的计算精度，并作出了计算验证。 - Status and Discussion about Application of Pipe Flange Standard in Pressure Vessels
管法兰标准在压力容器行业中的应用现状及探讨 - The computer controlled pressure measuring system is composed of a pressure scanning valve and a programmable standard pressure source controlled by a quartz pressure sensor.
计算机控制的压力测量实时校正系统由压力扫描阀，及石英压力传感器控制的可程控标准压力源等部份组成。在这种系统中，传感器的数量大大减少了。 - This paper from the working principle of static expansion method, pointed out the exist problem of the original device, redesigned the major parts and put forward a new way to test the preceding standard pressure.
从静态膨胀法的工作原理出发，指出原膨胀法测压装置存在的问题，对一些主要部件进行重新设计，提出前级标准压力测定新方法。 - Up till now, in the defect assessment standard of pressure vessel, a semi-experience method, equivalent K ( stress intensity factor) conversion, usually used to deal with beried and surface three dimen-sional crack.
在压力容器缺陷评定标准中对埋藏和表面三维裂纹问题的处理，通常采用半经验的等应力强度因子（K）换算方法。 - The problems in present assessment of the pressure temperature coefficient were pointed out, the variation law of the pressure temperature coefficient was systemically analyzed, and the method in calculating standard pressure coefficient was also established.
提出了目前评价压强温度系数所存在的问题，较系统地分析了压强温度系数的变化规律，建立了参比压强温度系数的计算方法。 - With the comparable parameter, the equivalent leakage, the standard of pressure test of some gas lines at home and abroad has been analysised in this paper.
用各试压工况的当量漏气量这一可比参数，对国内、外几种煤气管道的试压标准做了分析。 - The flash point test result is automatically corrected to standard pressure ( 101.3 kPa).
闪点测试结果会自动更正为标准压力（101.3千帕）。 - Just like we referenced everything to one bar before, as our standard pressure.
就像我们把所有的压强都和一巴作参考，作为标准压强。